China High Voltage Fuse Cutout /Fuse Link Breaker & Protector&Fuse - China Hv Fuse Link, Fuse

Product Description:
Outdoor drop fuse is suitable for up to and including 35 kv voltage frequency 50 hz in the power system, transmission lines, power transformer overload and short circuit protection, only device.the rated load current, a mechanical life 2000 times or more
Drop type fuse and tensile load falling type fuse is outdoor high voltage protection appliances, it assembled in distribution transformer high voltage side or distribution lines trunk road, transmission lines, power transformer overload and short circuit protection and device.the rated load current. According to fuse protection, the large amount of open circuit current should be no less than the maximum short-circuit current of protected electrical circuit;Minimum melting current should be no greater than was the minimum short circuit current protection circuit.
When installing fuse, should tighten all of the parts, to prevent contact part overheating during normal operation.
For three-phase install fuse piece, even if an action, the other two shall be replaced, because the other two, though not damaged, but is close to a point, to the extent of the damage.Vacuum fuse
Fuse cannot be installed on the severe vibration, dust, pollution, moist places.
The fuse save and check the fuse installation and replacement
To fall or the vibration of the fuse should be tested before use (dc resistance, the parts are in good condition)
Place a long time of fuse factory/outbound should be check again when the resistance value.
Fuse should be stored in dry places.
In replacement of fuse piece, should be replaced in the action after 10 minutes. If after fusing a movement found smoke emission tube or noisy phenomenon, should not replace the fuse, need, fusing and isolation are allowed to change after a power source.
For in near the power supply device or a charged conductor, should meet the safety regulations
1.ISO9001,C
2.90%exportation
3.good quality and reasonable price

Product Description
Outdoor Fuse Cutout 10KV-36KV
Application: Protection device for protecting power system from over-load and short-circuit failure. 
Ratings: 10kV-36kV. 
Standards: IEC 600282-2

Features: 
1, High over-current protection capability, high breaking current. 
2, High industrial frequency withstands voltage, and mechanical strength, etc. 
3, High quality on strict testing. 

Technical Data: 
Rated voltage: 11kV to 66kV. 
Rated current: Up to 200A. 

main technical parameters

 

 

TYPE	Rated Voltage (KV)	Rated Current (A)	Breaking Current (A)	Impulse Voltage (BIL) (KV)	Power-frequency wishtand voltage (KV)	Leakage Distance (MM) Voltage	Weight (KG)	Dimensions (CM)
RW3	10	100	6300	100	42	230	6.2	48X27X12
RW3	10	200	8000	100	42	230	6.5	48X27X12
HRW3	10	100	6300	100	42	230	6.2
HRW3	10	200	8000	110	42	230	6.2
RW7	10	100	6300	110	42	230	6.2	48X27X12
RW7	10	200	8000	110	42	230	6.5	48X27X12
HRW7	12	100	6300	110	42	230	6.2
HRW7	12	200	8000	110	42	230	6.2
RW10-10F	12	100	6300	110	42	260	7.5	53X32X12
RW10-10F	12	200	8000	110	42	260	7.5	43X32X12
HRW10	12	100	6300	110	42	260	7.5
HRW10	12	200	8000	110	42	260	7.5
RW12	15	100	10000	110	40	250	7.5	40X34.5X11
RW12	15	200	12000	110	40	250	7.5	40X34.5X11
RW12	24	100	8000	150	65	540	12	49X35X14
RW12	24	200	12000	150	65	540	12	49X35X14
RW12	30	100	6000	170	70	700	15	56X38X14.5
RW12	30	200	8000	170	70	700	15	56X38X14.5
RW12	33	100	10000	170	70	720	15.5	57X38X14.5
RW12	33	200	12000	170	70	720	15.5	57X37X14.5
RW12	11	100	6000	110	42	340	7.5	49X27X11.5
RW12	11	200	8000	110	42	340	7.5	49X27X11.5
RW11	36	100	6000	110	42	340	16	90X40X13
RW11	36	200	8000	170	70	870	16	90X40X13
RW5	33	100	8000	170	70	820	27.5	67X17X15
RW5	33	200	10000	170	70	820	27.5	68X17X15
HRW9	10	100	6300	110	42
HRW9	10	300	8000	110	42
HRW11	12	100	6300	100	42
HRW11	12	200	8000	110	42
HPRW11	12	100	6300	100	42
HPRW11	12	200	8000	110	42
HRW12	12	100	6300	100	42
HRW12	12	200	8000	110	42